Details

• Suitable for mounting on flat surfaces and high radial load capacities
• The housing is made of zinc die-cast
• The bearing insert has an extended inner ring with grub screws
• The pillow block bearing is mounted on the shaft with two grub screws
• The bearing insert can compensate for low static misalignment
• Two-piece sealing system: with sheet steel washer reinforced rubber seal inside; outside additionally with upstream slinger made of sheet steel for high mechanical protection against foreign matter
• Lubricated for life; under normal operating conditions re-lubrication is not required

A Pillow Block Bearing is a mounted anti-friction bearing that is contained within a solid cast iron, ductile iron or cast steel housing unit. Also referred to as a housed bearing unit, meaning they are self-contained, greased, sealed and ready for installation on the equipment.  Pillow Block bearings are typically bolted to a surface, so that the attached shaft runs parallel with the surface. 

Feature of Pillow Block Bearing

• The bearings have a compact design and are easy to mount and dismount
• With certain self-aligning effect
• Large load capacity
• Long service life
• Low friction; low vibration and low noise